Chemical Engineering
GATE CH exam:gate PYQs
Build your understanding with focused practice from past exam papers.
Questions 221–230 of 650. Imported answers require independent review unless marked reviewed.
Question 26
Open questionCHMCQ1 markNeeds review
A packed distillation column, with vapor having an average molecular weight of 45 kg·mol⁻¹, density of 2 kg·m⁻³ and a molar flow rate of 0.1 kmol·s⁻¹, has a flooding velocity of 0.15 m·s⁻¹. The column is designed to operate at 60 % of the flooding velocity. Which one of the following is the CORRECT value for the column diameter (in m)?
Your answerChoose one option.
Log in to check the answer
You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answerQuestion 27
Open questionCHMCQ1 markNeeds review
An isothermal jacketed continuous stirred tank reactor (CSTR) operating at 150 °C is shown in the figure below. The cold feed entering the system at 30 °C is preheated to a temperature
(
°C) using a heat exchanger
. This preheated feed is further heated to 150 °C using the utility heater
. The mass flow rate and heat capacity are same for all the process streams, and the overall heat transfer coefficient is independent of temperature. Which one of the following statements is the CORRECT action to take if it is desired to increase the value of
? 
Your answerChoose one option.
Log in to check the answer
You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answerQuestion 28
Open questionCHMSQ1 markNeeds review
Consider a system where a Carnot engine is operating between a source and a sink. Which of the following statements about this system is/are NOT correct?
Your answerSelect all correct options. You can choose more than one.
Log in to check the answer
You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answerQuestion 29
Open questionCHMSQ1 markNeeds review
For a fully developed turbulent flow of an incompressible Newtonian fluid through a pipe of constant diameter, which of the following statements is/are CORRECT?
Your answerSelect all correct options. You can choose more than one.
Log in to check the answer
You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answerQuestion 30
Open questionCHMSQ1 markNeeds review
Given that
(in W·m
) is the total hemispherical emissive power of a surface maintained at a certain temperature, which of the following statements is/are CORRECT?Your answerSelect all correct options. You can choose more than one.
Log in to check the answer
You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answerQuestion 31
Open questionCHNAT1 markNeeds review
The position
of a particle, at constant
, is described by the equation
The initial conditions are
and
. The position of the particle at
is __________ (in integer).Log in to check the answer
You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answerQuestion 32
Open questionCHNAT1 markNeeds review
Burning of methane in a combustor yields carbon monoxide, carbon dioxide, and water vapor. Methane is fed to the combustor at 100 mol·hr
, of which 50 % reacts. The theoretical oxygen requirement (in mol·hr
) is ________ (rounded off to one decimal place).Log in to check the answer
You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answerQuestion 33
Open questionCHNAT1 markNeeds review
The viscosity of an incompressible Newtonian fluid is measured using a capillary tube of diameter 0.5 mm and length 1.5 m. The fluid flow is laminar, steady and fully developed. For a flow rate of 1 cm
·s
, the pressure drop across the length of the tube is 1 MPa. If the viscosity of the fluid is
Pa·s, the value of
is __________ (rounded off to two decimal places).Log in to check the answer
You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answerQuestion 34
Open questionCHNAT1 markNeeds review
A liquid
containing a dissolved gas
is stripped in a countercurrent operation using a pure carrier gas
. The liquid phase inlet and outlet mole fractions of
are 0.1 and 0.01, respectively. The equilibrium distribution of
between
and
is governed by
, where
and
are the mole fractions of
in
and
, respectively. The molar feed rate of the carrier gas stream is twice that of the liquid stream. Under dilute solution conditions, the minimum number of ideal stages required is __________ (in integer).Log in to check the answer
You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answerQuestion 35
Open questionCHNAT1 markNeeds review
In a binary gas-liquid system,
is the molar flux of a gas A for equimolar counter diffusion with a liquid B.
is the molar flux of A for steady one component diffusion through stagnant B. Using the mole fraction of A in the bulk of the gas phase as 0.2 and that at the gas-liquid interface as 0.1 for both the modes of diffusion, the ratio of
to
is equal to _____ (rounded off to two decimal places).Log in to check the answer
You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answer