Questions 61–65 of 65. Imported answers require independent review unless marked reviewed.

Topic practice 65 questionsPage 7 of 7

Question 41

Open question
INNAT2 marksNeeds review
In the circuit, shown in the figure, the MOSFET is operating in the saturation zone. The characteristics of the MOSFET is given by

, where

is in V. If

, then the value of

in k

is __________.
Diagram for Instrumentation Engineering question 41


Log in to check the answer

You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answer

Question 42

Open question
INNAT2 marksNeeds review
The two-input voltage multiplier, shown in the figure, has a scaling factor of 1 and produces voltage output. If

and

, the value of

in volt is __________.
Diagram for Instrumentation Engineering question 42


Log in to check the answer

You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answer

Question 44

Open question
INNAT2 marksNeeds review
The circuit of a Schmitt trigger is shown in the figure.
Diagram for Instrumentation Engineering question 44

The zener-diode combination maintains the output between

. The width of the hysteresis band is __________ V.

Log in to check the answer

You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answer

Question 50

Open question
INNAT2 marksNeeds review
A resistance temperature detector (RTD) is connected to a circuit, as shown in the figure. Assume the opamp to be ideal. If

, then the value of

is ________.
Diagram for Instrumentation Engineering question 50


Log in to check the answer

You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answer

Question 52

Open question
INNAT2 marksNeeds review
The junction semiconductor temperature sensor shown in the figure is used to measure the temperature of hot air. The output voltage

is 2.1 V. The current output of the sensor is given by

where

is the temperature in K. Assuming the opamp to be ideal, the temperature of the hot air in °C is approximately ________.
Diagram for Instrumentation Engineering question 52


Log in to check the answer

You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answer