Production and Industrial Engineering
2022 · Paper 1
Take it one question at a time. Try an answer, then check your understanding.
Complete GATE PI 2022 Paper 1 overview, original pages and practice · Timed previous-paper practice
Questions 40–42 of 65. Imported answers require review unless explicitly marked reviewed.
Question 40
Open questionPIMCQ2 marksNeeds review
In the three-member truss shown in the figure, AC = BC. An external force of 10 kN is applied at B, parallel to AC. The force in the member BC is
Your answerChoose one option.
Log in to check the answer
You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answerQuestion 41
Open questionPIMCQ2 marksNeeds review
Match the processing steps related to production of powder metallurgy parts with their descriptions.
Processing step | Description |
|---|---|
P — Atomization | 1 — Blend powders are pressed into shapes using dies and pressure |
Q — Sintering | 2 — A process for producing metal powder |
R — Compaction | 3 — Metal powders are heated below their melting points to allow bonding |
S — Infiltration | 4 — A slug of low melting point metal is placed in contact with the sintered part and heated |
| 5 — Metal powders are heated significantly above their melting points for bonding |
Your answerChoose one option.
Log in to check the answer
You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answerQuestion 42
Open questionPIMCQ2 marksNeeds review
In an assembly comprising shaft and hole, the nominal sizes with tolerances are specified as
Hole: 25.000
mm,Shaft: 25.000
mm.The type of fit is
Your answerChoose one option.
Log in to check the answer
You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answer