GATE XE 2017 Paper 1 — page 25

Questions 73–75 of 175. Imported answers require review unless explicitly marked reviewed.

The simply supported beam shown below is subjected to a clockwise moment

at point A and to counterclockwise moments

and

at points B and C, respectively. Which one of the following is the correct bending moment diagram (tensile at bottom is positive moment) for the beam?

Diagram for Engineering Sciences question 73

Your answerChoose one option.

Diagram for Engineering Sciences question 73 (figure 2)

Diagram for Engineering Sciences question 73 (figure 3)

Diagram for Engineering Sciences question 73 (figure 4)

Diagram for Engineering Sciences question 73 (figure 5)

You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answer

The structure shown below is of rectangular cross section and carries a load of 10kN at its free end E. Maximum bending stress (in MPa) developed in the beam due the external load is _________. The depth of the beam is 300mm and the width is 150mm.

Diagram for Engineering Sciences question 74

You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answer

Two circular rods shown below carry the same axial load

. The Rod-A has uniform cross-section and the Rod-B has non-uniform cross-section as shown. The ratio of elongation of Rod-A to Rod-B is given by

Diagram for Engineering Sciences question 75

Your answerChoose one option.

1:1

1:2

2:1

3:1

You can attempt this question now. Sign in to view the answer key, explanations and discussion.Log in to check answer

2017 · Paper 1

Question 73

Question 74

Question 75